Image is an illustration, may not reflect the exact product sold.


Other products by Adafruit

Adafruit - 1657 - 1657 - Development Kit, Gemma Starter Pack, Wearables MCU, Conductive Thread, Jumper Cables

  • MFR SKU: 1657
  • ITEM #: 11463846
  • 0 Reviews / 0 Questions
$44.95
Stock Status: SHIPS SOON(reserve your unit today)

ITEM #: 11463846
Product Overview

Get started with Adafruit GEMMA with this lovely starter kit! Included is everything you need to make a basic project. There's a GEMMA board, four sewable bright RGB pixels, a battery holder (batteries not included, ) 2-ply conductive thread, alligator clips to help you test out your circuit, and a USB cable for programming GEMMA.
  • A microcontroller board small enough to fit into any project
  • Low cost enough to use without hesitation
  • It's...
ITEM #: 11463846
Product Overview

Get started with Adafruit GEMMA with this lovely starter kit! Included is everything you need to make a basic project. There's a GEMMA board, four sewable bright RGB pixels, a battery holder (batteries not included, ) 2-ply conductive thread, alligator clips to help you test out your circuit, and a USB cable for programming GEMMA.
  • A microcontroller board small enough to fit into any project
  • Low cost enough to use without hesitation
  • It's our lowest-cost sewable controller!
  • 6 Solderable Points
  • Super small, only 1.1"
  • Easy-to-sew or solder pads for embedding in your wearable project
  • Low cost enough, you can use one for every weekend project
  • ATtiny85 on-board, 8K of flash, 512 byte of SRAM, 512 bytes of EEPROM
  • Internal oscillator runs at 8MHz
  • Ultra low power, draws only 9 mA while running
  • USB bootloader with a nice LED indicator looks just like a USBtinyISP so you can program it with the Arduino IDE
  • Mini-USB jack for power and
  • ~5.25K bytes available for use (2.75K taken for the bootloader)
  • On-board 3.3V power regulator with 150mA output capability and ultra-low dropout
  • Power with either USB or external output (such as a battery) - it'll automatically switch over
  • On-board green power LED and red pin #1 LED
  • Reset button for entering the bootloader or restarting the program.
  • 3 GPIO - The 3 independent IO pins have 1 analog input and 2 PWM output as well.
Read More >>

Adafruit - 1657 - 1657 - Development Kit, Gemma Starter Pack, Wearables MCU, Conductive Thread, Jumper Cables

  • Item #: 11463846
  • MFR SKU: 1657

There are no questions about this product yet. Be the first to ask a question.

0 out of 5 stars
5 Star
0 %
4 Star
0 %
3 Star
0 %
2 Star
0 %
1 Star
0 %

Review this product

Tell us about your personal experience

Recently Viewed Items