Image is an illustration, may not reflect the exact product sold.


Other products by ITW Buildex

ITW Buildex - 5014901 - #8 Hole Dia. x 2-1/8" Zinc E-Z Ancor Self-Drilling Toggle Bolt w/ Screws

  • MFR SKU: 5014901
  • ITEM #: 16352133
  • 0 Reviews / 0 Questions
$602.90
Stock Status: SHIPS SOON (reserve your unit today)

ITEM #: 16352133
#8 Hole Dia. x 2-1/8" Zinc E-Z Ancor Self-Drilling Toggle Bolt w/ Screws
This listing is for UNT of 250

ITW Buildex - 5014901 - #8 Hole Dia. x 2-1/8" Zinc E-Z Ancor Self-Drilling Toggle Bolt w/ Screws

  • Item #: 16352133
  • MFR SKU: 5014901
  • Anchor Diameter 1/2"
  • Contents Anchor with screws
  • Finish Zinc
  • Length 2-1/8"
  • Material Steel
  • Min Clearance Behind Wall 2-1/2"
  • Min Wall Thickness 3/8"
  • Minimum Depth 1-7/8"
  • Screw Size #8
  • System of Measurement Imperial (Inch)
  • Type Toggle Bolt Anchor
  • Product Weight 2.4
  • Catalog Page BBV11, Page 01-331
  • Notes
  • Replaces plastic plugs and toggles. Deep thread design provides strong engagement in 3/8", 1/2" and 5/8" gypsum wallboard. Installs quickly and easily with a phillips screwdriver or square drive bit. Can be easily backed-out. Low profile head. Single point design for clean cutting installation.
  • Toggle anchor
  • Delivers 70-150lbs. Load capacity
  • Attach heavier loads to dry wall
  • EZ Ancor Drill Point
  • Predrills precise hole in gypsum wall board
  • No hole preparation required
  • Quick one tool installation
  • Only requires a Phillips screw driver
    • br> Electrical Fixtures. Thermostats. HVAC fixtures. Plumbing fixtures. Bathroom accessories. Shelving and supports. Mirrors. Picture Frames. Brackets. Plaques and awards. Closet organizers. Coat racks. Curtain rods. Signs. Bulletin boards. Control systems. Decorative wall hangings. Office material holders. Smoke detectors. Clocks. Kitchen accessories. Doorbells. Telecommunications equipment. Chalk boards. Remote control boxes. 1. Using a #2 Phillips screwdriver, drill the E-Z Toggle Anchor into drywall until the head of the anchor is seated flush. 2. To ?set? the clamp behind the drywall, place the mounting screw into the anchor and push or tap firmly until approximately 1" of screw is protruding (do not rotate). Then remove the screw. 3. Place fixture over E-Z Toggle, insert screw and continue to turn until fastened tightly (for example, when attaching a 1/2" thick fixture, it will require approx. 23 full rotations of the screwdriver to fully tighten the fixture).

There are no questions about this product yet. Be the first to ask a question.

0 out of 5 stars
5 Star
0 %
4 Star
0 %
3 Star
0 %
2 Star
0 %
1 Star
0 %

Review this product

Tell us about your personal experience

Recently Viewed Items