Image is an illustration, may not reflect the exact product sold.


Other products by Tycon Power Systems

Tycon Power Systems - EZBR-0516HD+ - Kit, Ez-bridge-lt5+hd Industrial Strength Point To Point Bridge System - Plug An

  • MFR SKU: EZBR-0516HD+
  • ITEM #: 9231498
  • 0 Reviews / 0 Questions
$445.01
Stock Status: SHIPS SOON (reserve your unit today)
Average lead time for this brand: 1-2 weeks. Specific products may vary.

ITEM #: 9231498
The EZ-Bridge LT+ HD is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 5GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec. It complies with the 802.11g/n or 802.11a/n standards to insure interoperability. The EZBridge LT+ HD creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play...
ITEM #: 9231498
The EZ-Bridge LT+ HD is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 5GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec. It complies with the 802.11g/n or 802.11a/n standards to insure interoperability. The EZBridge LT+ HD creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge LT+ HD units can be connected in a mesh configuration to allow interconnecting more than two sites.
With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.
Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.
The EZ-Bridge LT+ HD comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11g/n or 16dBi 802.11a/n MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Surge Protected Cat5e rated 24V PoE (Power Over Ethernet) power inserters and 75 shielded outdoor rated CAT5 cable assemblies.
The EZBR-0516+ management interface is IPv6 enabled, https enabled. Logon username is fixed. The password can be changed, and there are no rules for password length or content.
Read More >>

Tycon Power Systems - EZBR-0516HD+ - Kit, Ez-bridge-lt5+hd Industrial Strength Point To Point Bridge System - Plug An

  • Item #: 9231498
  • MFR SKU: EZBR-0516HD+
  • Data Rates
  • 5GHz 802.11n: up to 300Mbps
  • 5GHz 802.11a: up to 54Mbps
  •  
  • Standards
  • IEEE802.11g/n, 802.11a/n, 802.3, 802.3u
  •  
  • Power Requirements
  • Power Supply: 100-240VAC 50/60Hz
  • EZ-Bridge ® : 12VDC to 24VDC Passive PoE
  • Average Power Consumption: 4W
  •  
  • Regulatory Certifications
  • FCC Part 15 / UL
  •  
  • RF Frequency Band
  • 5100 ~ 5850 MHz
  •  
  • Modulation Technology
  • 802.11n: TDMA
  • 802.11g: OFDM
  • 802.11a: OFDM
  •  
  • Receive Sensitivity (Typical)
  • 802.11n: -90 dBm
  • 802.11g: -75 dBm
  • 802.11a: -75 dBm
  •  
  • Transmit Power
  • 25dBm   316mW
  •  
  • DC Connector Power Out
  • Input Voltage @ Max 10W
  • Antenna
  • 5GHz 16dBi MIMO Panel Antenna, 27deg Beamwidth, > 22dB front to back
  •  
  • Operation Mode – Bridge or Router
  • Point to Point Bridge, Access Point, Access Point WDS, Client, Client WDS
  •  
  • Interface
  • 10/100Mbps RJ-45 LAN Port x 2
  •  
  • IP Configuration
  • Static or Auto configuration using DHCP Client
  •  
  • Security
  • MAC Address Filtering, WEP/WPA encryption, Hide SSID in beacons, Layer 2 isolation
  •  
  • Management Configuration
  • Web-based configuration (HTTP)
  • Console configuration (SSH)
  • SNMP Protocol
  •  
  • Firmware Upgrade
  • Upgrade firmware via web browser
  •  
  • Antenna Physical Dimensions (L x W x D)
  • 314mm x 187mm x 65mm
  • 12.4” x 7.3” x 2.5”
  •  
  • Complete System Weight: 3 kg   (7 lbs )
  •  
  • Operating Temperature
  • -30°C to +70°C (-22°F to 158°F)
  •  
  • Warranty: 2 Years
  •  

There are no questions about this product yet. Be the first to ask a question.

0 out of 5 stars
5 Star
0 %
4 Star
0 %
3 Star
0 %
2 Star
0 %
1 Star
0 %

Review this product

Tell us about your personal experience

Recently Viewed Items